R&S FSW Series - Carrier-To-Noise Configuration

Measurements and Results
R&S
®
FSW
210User Manual 1173.9411.02 ─ 43
Remote command:
You can also query the determined carrier-to-noise ratio via the remote command
CALC:MARK:FUNC:POW:RES? CN or CALC:MARK:FUNC:POW:RES? CN0, see
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult? on page 837.
7.3.3 Carrier-to-Noise Configuration
Access: "Overview" > "Select Measurement" > "C/N"/"C/N0" > "Carrier Noise Config"
Both a carrier-to-noise ratio (C/N) and a carrier-to-noise ratio in relation to the band-
width (C/N
0
) measurement are available.
Carrier-to-noise measurements are not available in zero span mode.
Carrier-to-Noise Measurements