R&S FSW Series - Configuring Bandwidth and Sweep Settings

Remote Commands
R&S
®
FSW
1030User Manual 1173.9411.02 ─ 43
Parameters:
<Level> The unit depends on CALCulate<n>:UNIT:POWer.
Range: -130 dBm to 30 dBm
*RST: -120 dBm
Default unit: DBM
Manual operation: See "Signal Tracking" on page 447
CALCulate<n>:MARKer<m>:FUNCtion:STRack:TRACe <TraceNumber>
This command selects the trace on which the largest signal is searched for.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<TraceNumber> 1 to 6
Range: 1 to 6
*RST: 1
Manual operation: See "Signal Tracking" on page 447
14.7.2 Configuring Bandwidth and Sweep Settings
The commands required to configure the bandwidth, sweep and filter settings in a
remote environment are described here. The tasks for manual operation are described
in Chapter 8.5, "Bandwidth, Filter and Sweep Configuration", on page 459.
● Configuring the Bandwidth and Filter..................................................................1030
● Configuring the Sweep........................................................................................1034
14.7.2.1 Configuring the Bandwidth and Filter
[SENSe:]BWIDth[:RESolution].......................................................................................1031
[SENSe:]BANDwidth[:RESolution]................................................................................. 1031
[SENSe:]BWIDth[:RESolution]:AUTO.............................................................................1031
[SENSe:]BANDwidth[:RESolution]:AUTO........................................................................1031
[SENSe:]BWIDth[:RESolution]:RATio............................................................................. 1031
[SENSe:]BANDwidth[:RESolution]:RATio........................................................................1031
[SENSe:]BWIDth[:RESolution]:TYPE..............................................................................1032
[SENSe:]BANDwidth[:RESolution]:TYPE........................................................................ 1032
[SENSe:]BWIDth:VIDeo................................................................................................1032
[SENSe:]BANDwidth:VIDeo.......................................................................................... 1032
[SENSe:]BWIDth:VIDeo:AUTO......................................................................................1033
[SENSe:]BANDwidth:VIDeo:AUTO.................................................................................1033
[SENSe:]BWIDth:VIDeo:RATio...................................................................................... 1033
[SENSe:]BANDwidth:VIDeo:RATio.................................................................................1033
[SENSe:]BWIDth:VIDeo:TYPE.......................................................................................1033
[SENSe:]BANDwidth:VIDeo:TYPE................................................................................. 1033
Setting Basic Measurement Parameters