Remote Commands
R&S
®
FSW
822User Manual 1173.9411.02 ─ 43
1
Resets the status registers.
*RST
Reset
Sets the instrument to a defined default status. The default settings are indicated in the
description of commands.
The command is equivalent to SYSTem:PRESet.
Note that the factory set default values can be modified to user-defined settings (see
MMEMory:LOAD:STATe on page 1238). For more details on default values, see
Chapter 11.1, "Restoring the Default Instrument Configuration (Preset)", on page 622.
Usage:
Setting only
*SRE <Contents>
Service request enable
Sets the service request enable register to the indicated value. This command deter-
mines under which conditions a service request is triggered.
Parameters:
<Contents> Contents of the service request enable register in decimal form.
Bit 6 (MSS mask bit) is always 0.
Range: 0 to 255
*STB?
Status byte query
Reads the contents of the status byte in decimal form.
Usage:
Query only
*TRG
Trigger
Triggers all actions waiting for a trigger event. In particular, *TRG generates a manual
trigger signal. This common command complements the commands of the TRIGger
subsystem.
*TRG corresponds to the INITiate:IMMediate command (see INITiate<n>[:
IMMediate] on page 836).
Usage:
Event
Common Commands
To Next Page
Loading...
