EasyManua.ls Logo

R&S FSW Series - Page 887

R&S FSW Series
1450 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Commands
R&S
®
FSW
887User Manual 1173.9411.02 ─ 43
MSR Channel Names
The functions for manual operation are described in Chapter 7.2.5.5, "MSR Channel
Names", on page 193.
[SENSe:]POWer:ACHannel:NAME:GAP<gap>..................................................................887
[SENSe:]POWer:ACHannel:NAME:UACHannel................................................................ 887
[SENSe:]POWer:ACHannel:NAME:UALTernate<ch>......................................................... 887
[SENSe:]POWer:ACHannel:SBLock<sb>:NAME[:CHANnel<ch>]........................................887
[SENSe:]POWer:ACHannel:NAME:GAP<gap> <Name>
This command queries the name of the GAP channel.
Suffix:
<gap>
.
1 | 2
Gap (CACLR) channel number
Parameters:
<Name> String containing the name of the channel
*RST: 'Gap1', 'Gap2'
[SENSe:]POWer:ACHannel:NAME:UACHannel <Name>
This command defines the name for the upper adjacent channel in asymmetrical MSR
channel definitions. To define the name for the lower adjacent channel use the
[SENSe:]POWer:ACHannel:NAME:ACHannel command.
Parameters:
<Name> String containing the name of the channel
*RST: ADJ
[SENSe:]POWer:ACHannel:NAME:UALTernate<ch> <Name>
This command defines the name for the specified upper alternate channel in asymmet-
rical MSR channel definitions. To define the name for the lower adjacent channels use
the [SENSe:]POWer:ACHannel:NAME:ALTernate<ch> command.
Suffix:
<ch>
.
1..n
Alternate channel number
Parameters:
<Name> String containing the name of the channel
*RST: ALT<1...11>
[SENSe:]POWer:ACHannel:SBLock<sb>:NAME[:CHANnel<ch>] <Name>
This command defines the name of the specified MSR Tx channel.
This command is for MSR signals only.
Configuring and Performing Measurements

Table of Contents

Related product manuals