R&S FSW Series - Page 954

Remote Commands
R&S
®
FSW
954User Manual 1173.9411.02 ─ 43
14.5.8.2 Configuring a Sweep List
The following commands configure the sweep list for spurious emission measure-
ments.
The sweep list cannot be configured using remote commands during an on-going
sweep operation.
Useful commands for configuring the sweep described elsewhere:
●
[SENSe:]SWEep:MODE on page 919
●
[SENSe:]LIST:RANGe<ri>[:FREQuency]:STARt on page 924
●
[SENSe:]LIST:RANGe<ri>[:FREQuency]:STOP on page 925
Remote commands exclusive to spurious measurements:
[SENSe:]LIST:RANGe<ri>:BANDwidth:RESolution............................................................ 954
[SENSe:]LIST:RANGe<ri>:BANDwidth:VIDeo................................................................... 955
[SENSe:]LIST:RANGe<ri>:BREak....................................................................................955
[SENSe:]LIST:RANGe<ri>:COUNt?..................................................................................955
[SENSe:]LIST:RANGe<ri>:DELete................................................................................... 956
[SENSe:]LIST:RANGe<ri>:DETector.................................................................................956
[SENSe:]LIST:RANGe<ri>:FILTer:TYPE............................................................................956
[SENSe:]LIST:RANGe<ri>:INPut:ATTenuation...................................................................957
[SENSe:]LIST:RANGe<ri>:INPut:ATTenuation:AUTO......................................................... 957
[SENSe:]LIST:RANGe<ri>:INPut:GAIN:STATe...................................................................958
[SENSe:]LIST:RANGe<ri>:INPut:GAIN[:VALue].................................................................958
[SENSe:]LIST:RANGe<ri>:LIMit:STARt.............................................................................959
[SENSe:]LIST:RANGe<ri>:LIMit:STATe.............................................................................959
[SENSe:]LIST:RANGe<ri>:LIMit:STOP............................................................................. 959
[SENSe:]LIST:RANGe<ri>:POINts[:VALue]....................................................................... 960
[SENSe:]LIST:RANGe<ri>:RLEVel................................................................................... 960
[SENSe:]LIST:RANGe<ri>:SWEep:TIME.......................................................................... 960
[SENSe:]LIST:RANGe<ri>:SWEep:TIME:AUTO................................................................ 961
[SENSe:]LIST:RANGe<ri>:TRANsducer........................................................................... 961
[SENSe:]LIST:RANGe<ri>:BANDwidth:RESolution <RBW>
This command defines the resolution bandwidth for a spurious emission measurement
range.
Suffix:
<ri>
.
1..n
Selects the measurement range.
Parameters:
<RBW> Resolution bandwidth.
Refer to the data sheet for available resolution bandwidths.
Default unit: Hz
Example:
LIST:RANG2:BAND:RES 3KHZ
Configuring and Performing Measurements