Data Management
R&S
®
FSW
627User Manual 1173.9411.02 ─ 43
limit line or transducer files (see Chapter 11.3.2.1, "Stored Data Types",
on page 629).
Saving instrument settings in secure user mode
Settings that are saved via Quick Save in secure user mode are stored to the SDRAM,
and are only available during the current session. As soon as the power is switched off
on the R&S FSW, the data is cleared (see Chapter 5.1.7, "Protecting Data Using the
Secure User Mode", on page 43).
During recall, save sets of type "Instrument" replace the settings of the entire instru-
ment. All other save sets start a new channel with the stored settings.
If a channel with the same name as the "Channel" to be restored is already active, the
name for the new channel is extended by a consecutive number:
11.3.1.1 Quick Save / Quick Recall Settings
Access: "Save"/ "Open" icon in the toolbar > "Quick Save" / "Quick Recall"
Both dialog boxes are very similar and closely related.
Storing and Recalling Instrument Settings and Measurement Data
To Next Page
Loading...
