Rockwell Automation Publication 2198-UM002L-EN-P - October 2021 195
Chapter 6 Configure and Start the Kinetix 5700 Drive System
10. Right-click the DC-bus power supply you just created in the Controller
Organizer and choose Properties.
The Module Properties dialog box appears.
11. Click the Digital Input category.
12. From the Digital Input pull-down menu choose Bus Capacitor OK or
Shunt Thermal Switch OK to monitor your capacitor module status or
the shunt thermal switch, respectively, depending on your application.
In this example, Bus Capacitor OK is chosen.
13. Click the Associated Axes category.
14. Click New Axis.
To configure the remaining DC-bus power supply properties, you
must close the New Module dialog box and reopen it as the Module
Properties dialog box.
To Next Page
Loading...
Need help?
General
