Operation
Steering
173 / 476
If the all-wheel steer was not activated, then the cause of it is shown on the R-
Touch:
– Unlock the main steering switch (44)
– Drive faster, the minimum speed (0.5 km/h) shouldn’t be reached.
– The speed is too high. Please continue reducing the speed.
ADVICE
Once the main steering switch is opened in the operating mode "Rabbit", the speed
is reduced automatically for the safety reasons. If the keys (12) and (13) on the joy-
stick are pressed and held in such a way at too high speed and opened main steer-
ing switch, at first the speed is reduced automatically to the maximum activation
speed, and then the function "All-wheel steer" becomes active. Then the keys can be
released again.
In case you need to continue driving with high or maximum speed, please perform the
following actions:
– Set rear axle to central position (see following section)
– Lock the main steering switch
6.11.1.3 Put rear axle in central position
11
– Select operating mode „Rabbit“
– Drive slowly (below 12 km/h).
– Unlock the main steering switch (44)
– Drive at least 0.5 km/h and shortly press the multi-key (11) on the joystick
This sets the rear wheels straight.
Then, the main steering switch must IMMEDIATELY be locked again.
If the rear axle is not locked in central position, then during driving in operating mode
"Rabbit II", the following warning icon is displayed on the R-Touch.
To Next Page
Loading...
