Operation
Diesel engine
143 / 476
6.6.1 Start diesel engine
If the gas pedal is not in resting position during starting, then for safety reasons, trac-
tion drive is blocked. The block remains for so long until the gas pedal is completely
released and pressed again.
ATTENTION
Danger of machine damage.
Use of chemical starting aids (e.g. Startpilot etc.) is expressly prohibited, because this
may lead to injuries and to damage to the machine.
The ignition lock has three switching positions:
Position 0: Shut down engine/ignition off – the key may be removed
Position I: Ignition on, the engine is ready for starting
Position II: Start engine (not connected)
355541
The engine is started with the key START and shut down using the key STOP
or ignition lock.
ADVICE
After each start of the engine, the fan of the cooling system is automatically reversed
for a short time. This frees the cooling system of loose dirt (leaves, etc.).
If the engine does not start immediately, then the electronic system switches off the
starter after a certain period of time. In this case, wait at least 2 minutes until the next
try to start so that the starter can sufficiently cool down.
If the engine cannot be started due to a starting block, then the R-Touch displays the
following warning icon:
This warning icon and one of the following alternately flash on the R-Touch:
Please swing up rear platform
wall
Please close engine housing
door
To Next Page
Loading...
