Safety
Safety and protective equipment
37 / 476
2.24 General safety instructions for the park heating system
The heating appliance may not be operated in enclosed rooms, not even under
timer control or "Telestart" (e.g. garage or workshops without exhaust-gas extrac-
tion).
Due to the explosion hazard, the heating system must be switched off at gas sta-
tions and fuel dispensing systems.
Due to explosion hazard, the heating system must be shut off in any place where
combustible fumes or dust can form (e.g. near fuel, coal, wood dust or grain stor-
age or similar).
The heating system must be checked by a specialist at the latest at the start of the
heating season.
In cases of continual generation of dense smoke, unusual combustion sounds or
smell of fuel fumes, the heating system must be taken from operation by removing
the fuse and may only be recommissioned after inspection by personnel trained by
Webasto for this work.
Only diesel is to be used as fuel.
A temperature of 120°C must not be exceeded in the vicinity of the heating system.
Excess temperature may cause permanent damage to the electronics.
2.25 Safety and protective equipment
Perform a documented function test after work on safety equipment. Perform a regular
function check of safety equipment, keep maintenance intervals.
The safety equipment of the machine consists of:
Emergency stop switch in the operating console.
Back run warning system.
Battery main switch.
Battery emergency stop switch.
Protective covers, protective doors, safety switches.
Safety circuits.
Rotating beacons.
Protection bars.
DANGER
Risk of inactive safety devices.
Defect or overridden protective devices can not prevent from severe injuries and haz-
ards.
– After maintenance work and before the restart of the machine, make sure in any
case that all protective devices are fully assembled and functional.
To Next Page
Loading...