Operation
Loading operation
219 / 476
6.13.6 Beet path
This section of the R-Touch depicts in symbols the flow of beets through the machine.
This clearly presents all important operational parameters to you.
C
B
D D
E
F F
E
The following general meaning is allocated to the individual colors and icons:
white = component is switched off
green = component is activated, but not in motion
green with black arrows = component is moving in the working direction
green with red arrows = component is overloaded
red = component is blocked
orange with arrows = component is reversed; it is moving against the
working direction
Set the speed of the complete beet flow as optimally as possible. Match the speeds
of the pickup rollers to the 4-set (quadruple) pinch rollers. Set the rotational speeds of
the pickup rollers and 4-set pinch rollers to such a high speed that the beets picked up
are moved to the infeed conveyor without blockages.
When selecting the rotational speed, consider the degree of soiling of the beets. In
case of very soiled beets and wet ground, you should select a higher speed. This
means that the rollers should be running faster than under "good" conditions.
To Next Page
Loading...
