Maintenance and Service
Pickup
349 / 476
7.8.2 Pickup gears
The machine is fitted with three gearboxes on the outside right and left of the pickup.
Park the machine on level ground. The oil level of the six gearboxes must be checked
daily with the pickup folded out and lowered. The oil level can be read in the inspec-
tion glass (2). It must be within the inspection glass range (in no case above the top
edge of the inspection glass!).
The first oil change is required after 50 operating hours, further oil changes must be
performed annually.
2
1
1
3
3
3
2
2
1
6 5 4
(1) Oil filling screw
(2) Inspection glass
(3) Oil drain screw
(4) Pickup roller gearbox
(5) Conveyor roller gearbox
(6) 4-set pinch roller gearbox
Proceed as follows for changing the oil:
– Change the oil only with gears warm after operation.
– Park the machine on level ground.
– Put an oil-resistant collecting vessel of sufficient size underneath.
– Turn off the closing cap of the oil drain screw.
– Open the oil level filling screw and wait until the oil has drained completely.
– Reinsert the oil drain screw.
– Add fresh oil in the filler opening (also the bleeding screw) until the oil level is in the
upper section of the inspection glasses with the pickup lowered.
Prescribed oil variants: Gear oil
API GL5, SAE 90
Filling volume:
per pickup roller gearbox: approx. 9.0 litres
per conveyor roller gearbox: approx. 3.5 litres
per 4-set pinch roller gearbox: approx. 1.4 litres
To Next Page
Loading...
