Operation
Loading operation
223 / 476
6.13.8 Recleaner (drive B)
Depending on equipment, your machine has a sieve conveyor cleaner or an 8-set
pinch roller cleaner. This performs recleaning of the beets. The recleaner is located
between the infeed conveyor and the truck conveyor. The drive for the recleaner is
only operating when the machine drive has already been switched on.
Briefly press the key (9) on the right joystick once to switch on the recleaner.
If this key is pressed briefly again, then the drive for the recleaner is switched off. If
this key is pressed and held pressed, then the rotating direction of the recleaner is
reversed. Reversing of the recleaner is only possible for the version with a pinch roller
cleaner.
Rpm recleaner
The rotational speed of the recleaner may be set to one
of 10 stages. Choose this function with R-Select.
+ key = more aggressive recleaning
- key = gentler recleaning
Only in case of 8-set pinch roller recleaner: If the key + is released after the stage 10 is
reached and then pressed for at least three seconds, the "Max" stage is reached. The
highest hydraulic drive speed is achieved in the "Max" stage.
ADVICE
To treat the beets as carefully as possible, the speed of the recleaner should not be
selected higher than necessary. The stage "MAX" should only be used in case of
extremely sticky soil. In this stage, the speed of the pinch roller cleaner is exclusively
dependent on the speed of the diesel engine.
If this drive is stopped, all forward drives will also stop.
To Next Page
Loading...
