Operation
Loading operation
233 / 476
The pickup rollers have different tasks. They pick up the beets from the ground and
transfer them to the cleaner rollers. These forward the beets to the conveyor rollers
and simultaneously clean the pig tails of the pickup rollers.
The pickup rollers always move in working direction if the 4-set pinch rollers also move
in the working direction.
To switch on the pickup rollers (can be switched on jointly with the conveyor rollers),
briefly press the key (7) on the right joystick once.
When this key is briefly pressed again, the conveyor rollers/pickup rollers stop. If this
key is pressed and held pressed, then the rotating direction of the conveyor rollers/
pickup rollers is reversed.
Rpm pickup rollers
Choose this function with R-Select.
+ key = increase speed (rollers rotate faster)
- key = decrease speed (rollers rotate slower)
To treat the beets as carefully as possible, the speed of the pickup rollers should not
be selected higher than necessary.
If the warning limit of the pickup rollers is exceeded, then the following warning icon
is displayed on the R-Touch.
If the pickup rollers are blocked, then the following warning icon is displayed on the
R-Touch.
The traction drive stops automatically as soon as the pickup rollers are stopped or
reversed.
To Next Page
Loading...
