Section 09 COOLING SYSTEM
Subsection 01 (CIRCUIT, COMPONENTS AND CARE)
F06L0GA
max. 90°
TYPICAL
Towing the Watercraft in Water
Special precautions should be taken when towing
a Sea-Doo watercraft in water.
Maximum recommended towing speed is
24 km/h (15 MPH).
When towing your watercraft in water, pinch the
water supply hose from the jet pump housing to
theenginewithalargehosepincher(P/N529032
500).
F01B23A
This will prevent the cooling system from fillin
g
which may lead to water being injec
tedintoand
filling the exhaust system. Wit
hout the engine
running there isn't any exhau
st pressure to carry
the water out the exhaust ou
tlet.
CAUTION: Failure to do this may result in dam-
age to the engine. If you must tow a strand-
ed watercraft in water and do not have a hose
pincher be sure to stay well below the maxi-
mum towing speed of 24 km/h (15 MPH).
Snugly install the hose pincher on the water sup-
ply hose as shown in the following illustrations.
NOTE: Pinch the hose with the red tape (if so
equipped).
F02E04A
1
717 ENGINE
1. Hose pincher on water supply hose
smr2004-Complete Line Up 481
To Next Page
Loading...
Need help?
General
