Section 05 ENGINE (4-TEC)
Subsection 06 (LUBRICATION SYSTEM)
Oil Filling
Refill engine with oil meeting the specific require-
ments of the engine. Refer to TECHNICAL DATA.
Reinstall oil filler cap and dipstick.
NOTE: Oil filter should be replaced whenever re-
placing the engine oil.
Oil Type and System Capacity
Refer to TECHNICAL DATA. For refilling proce-
dure, refer to OIL LEVEL VERIFICATION above.
OIL FILTER
Removal
Remove:
– oil filter screw no. 1
– oil filter cover no. 2
– oil filter no. 3.
1
R1503motr114A
23
TYPICAL
1. Oil filter screw
2. Oil filter cover
3. Oil filter
Place rags in filler area to prevent spillage. If
spillage occurs, clean immediately with the pul-
ley flange cleaner (P/N 413 711 809) to prevent
stains.
WARNING
Wear safety glasses and work in a well venti-
lated area when working with strong chem-
ical products. Also wear suitable non-ab-
sorbent gloves to protect your hands.
Inspection
Check oil filter cover O-ring no. 4 and oil filter
screw O-ring, change if necessary.
Check and clean the oil filter inlet and outlet area
for dirt and other contaminations.
1
R1503motr115A
2
TYPICAL
1. Inlet bore from the oil pump to the oil filter
2. Outlet bore to the engine oil providing system
Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
Install a new oil filter.
Install O-ring on oil filter cover.
R1503motr116A
TYPICAL
Torque oil filter screw to 9 N•m(80lbf•in).
240 smr2004-Complete Line Up
To Next Page
Loading...
Need help?
General
