Section 16 HULL/BODY
Subsection 01 (ADJUSTMENT AND REPAIR)
2
F18L1ZA
1
1. Bottom support bracket
2. Shock bottom locking device
1
F18L20A
3
2
1. Shock absorber
2. Flat screwdriver
3. Shock top locking device
STORAGE COMPARTMENT
COVER ADJUSTMENT
NOTE: Apply Loctite 243 on threads of lock pin
when the adjustment is required or when the lock
pin is removed then reinstalled. The threads on
new lock pin are coated with a self-locking prod-
uct, do not apply Loctite 243 on threads.
All Models
Adjust lock pin no. 3 as per following specifica-
tions:
F06L04A
A
2
1
FIXED TYPE LOCK PIN
1. Lock pin (apply Loctite 243)
2. Adjustment nut. Torque to 5 N•m(44lbf•
in)
A. 34 ± 1 mm (1-11/32 ± 3/64 in)
2
F16L0UA
1
3
A
FLOATING TYPE
1. Lock pin (apply Loctite 243)
2. Rubber washer
3. Lock nut. Torque to 5 N•m(44lbf•
in)
A. 39.2 ± 1 mm (1-35/64 ± 3/64 in)
NOTE: Some models have a floating type lock pin.
It is normal to have a front and aft play of the lock
pin. To adjust, tighten lock pin until any vertical
play is eliminated. Make sure a front and aft play
remains when pressing by hands.
smr2004-Complete Line Up 745
To Next Page
Loading...
Need help?
General
