Section13PROPULSION
Subsection 02 (DRIVE SYSTEM)
F18B03A
Install drive shaft/floating ring tool as shown. En-
sure PTO seal support is still in place.
Push floating ring rearwards and install circlip.
1
F18I0NA
TYPICAL
1. Largest opening on through-hull fitting side
F18I06A
2
1
TYPICAL
1. Largest opening
2. Install circlip
Remove drive shaft/floating ring tool, drive shaft
holder then PTO seal support.
NOTE: Pushing boot no. 10 rearwards will ease
removal of PTO seal support tool.
Now ensure everything is properly positioned:
Tell tale is not exposed, inner sleeve is flush with
outer circumference of PTO seal assembly and
C-clip is not exposed.
If tell tale mark is exposed, push PTO seal assem-
bly rearwards to fully extend it.
If inner sleeve is not flush, gently tap it until it is
flush.
Reposition splash guard.
Reconnect EGTS sensor.
Install jet pump. Refer to JET PUMP section.
Check engine oil level. Refill as necessary.
Run watercraft then ensure there is no oil leak in
PTO seal area.
LUBRICATION
PTO Flywheel
GTI Series
Using a grease gun, carefully lubricate PTO fly-
wheel with synthetic grease (P/N 293 550 010),
until boot is just beginning to expand. At this
point, immediately stop greasing.
smr2004-Complete Line Up 673
To Next Page
Loading...
Need help?
General
