Section02MAINTENANCE
Subsection 04 (STORAGE)
STORAGE
ENGINE DRAINING
All Carburetor-Equipped Engines
Check engine drain hose (lowest hose of engine).
Make sure there is no sand or other particles in it
and that it is not obstructed so that water can exit
the engine. Clean hose and fitting as necessary.
CAUTION: Water in engine drain hose must
be free to flow out, otherwise water could be
trapped in engine. Should water freeze in en-
gine, severe damage will occur. Check engine
drain hose for obstructions.
F07E0MA
1
TYPICAL
1. Engine drain hose
RFI Models
Disconnect the water supply hose used to cool
the magneto. It features a quick connect fitting.
Press both tabs and pull fitting in order to discon-
nect hose.
This hose is located at the bottom of the magneto
cover beside the engine support.
F17E0AA
1
TYPICAL
1. Press tabs here and disconnect hose
Water should flow out of the fitting (magneto cool
ing circuit) and hose (crankcase heat exchanger).
Pushandholdhoseagainstbilgesothatdraining
can take place.
1
2
F17E0BA
1. Fitting
2. Hose
smr2004-Complete Line Up 39
To Next Page
Loading...
Need help?
General
