Section 14 STEERING SYSTEM
Subsection 01 (STEERING SYSTEM)
1
F18K0JA
2
1. Steering support
2. Retaining strip studs
Remove steering support no. 12 with handlebar,
wiring harnesses and cables.
Steering Stem Arm and Support
Loosen bolts no. 17 retaining steering stem arm
no. 15 to support no. 16.
F07K08A
21
2
1. Steering stem arm
2. Bolts
Remove steering stem arm and support.
Steering Stem and Steering Support
GTX 4-TEC Supercharged Limited Models Only
Unscrew nut and remove pivot bolt no. 47 re-
taining steering support no. 48 to steering stem
no. 49.
Remove adjuster screw from block and detach
steering support from steering stem.
Unscrew threaded pivots to remove threaded
block from steering stem no. 49.
F07K0PA
2
3
1
5
4
6
1. Steering stem
2. Steering support
3. Support bushing
4. Adjuster screw
5. Threaded block
6. Threaded pivots
Steering Cable
Disconnect steering cable no. 24 from steering
stem arm no. 15.
Remove retaining block no. 10.
Disconnect ball joint no. 19 from jet pump nozzle.
Remove ball joint no. 19 and jam nut from cable.
Loosen nut no. 25, then remove half rings no. 26
and O-ring no. 27.
NOTE: To loosen nut, use steering cable tool
(P/N 295 000 145).
Remove steering cable from watercraft.
ASSEMBLY
Assembly is essentially the reverse of disassem-
bly procedures. However, pay particular attention
to the following.
CAUTION: Apply all specified torques and ser-
vice products as per main illustration at the be-
ginning of this subsection.
692 smr2004-Complete Line Up
To Next Page
Loading...
Need help?
General
