Section 02 MAINTENANCE
Subsection 02 (FLUSHING AND LUBRICATION)
Models without a Flushing Connector
in Engine Compartment
Disconnect the garden hose.
CAUTION: Remove flushing adapter after oper-
ation (if used).
Models with a Flushing Connector in
Engine Compartment
Unlock and remove coupler hose. Reinstall dust
cap over flushing connector.
Remove hose pincher from water outlet hose.
CAUTION: Serious damage to exhaust system
can occur if hose pincher is not removed.
NOTE: Engine valves fogging should be done
whenever the watercraft is to be stored for a long
period. Refer to STORAGE section.
ANTICORROSION TREATMENT
All Models
To prevent corrosion, spray a corrosion inhibitor
(salt water resistant) such as BOMBARDIER
LUBE lubricant or equivalent over metallic com-
ponents in engine compartment.
Apply dielectric grease (salt water resistant) on
battery posts and cable connectors.
32 smr2004-Complete Line Up
To Next Page
Loading...
