To Next Page

To Previous Page

Section 13 PROPULSION

Subsection 04 (VARIABLE TRIM SYSTEM)

F01J1WA

1. Press tabs to remove cover

Motor

Disconnect wires from motor no. 8.

Remove retaining nuts no. 11.

F01J1XA

1. Remove nuts

2. Disconnect wires

Pull on motor to remove it.

Worm and Sliding Shaft

Simply pull on worm no. 9 and sliding shaft no. 10

in order to remove them.

INSPECTION

Boot

Make sure boot no. 3 is in good condition. If it is

cracked or torn, replace boot.

Worm

Inspect threads and splines of worm no. 9 for

wear. If worm replacement is necessary, renew

also sliding shaft.

F01J25A

1. Inspect threads and splines

ASSEMBLY

Assembly is essentially the reverse of disassem-

bly procedures. However pay particular attention

to the following.

Motor, Worm and Sliding Shaft

Apply synthetic grease to worm.

Screw worm no. 9 to sliding shaft no. 10.

Mesh worm splines to gear of motor.

F01J2PA

1. Mesh worm spline to gear of motor

Install motor no. 8, worm and sliding shaft in VTS

housing.

682 smr2004-Complete Line Up

SeaDoo GTI User Manual

Questions and Answers: