Section 05 ENGINE (4-TEC)
Subsection 05 (PTO HOUSING/MAGNETO)
R1503motr48A
TYPICAL
Inspection
Check if seal no. 13 is brittle, cracked or hard.
Check coupling for worn splines.
If damaged, replace faulty part.
R1503motr49A
Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
Torque PTO coupling to 250 N•m (184 lbf•ft). Ap-
ply Loctite anti-seize on threads.
STATOR
Removal
Remove:
– PTO housing (refer to PTO HOUSING RE-
MOVAL elsewhere in this section)
– holding plate no. 14 with CPS no. 15
1
R1503motr21A
2
3
TYPICAL
1. CPS screws
2. Holding plate
3. CPS
– screws no. 16
– stator no. 17.
1
R1503motr26A
2
TYPICAL
1. Stator screws
2. Stator
Inspection
Check stator and CPS condition. If damaged re-
place the faulty part.
For electrical inspection, refer to CHARGING
SYSTEM for the stator and to ENGINE MANAGE-
MENT for the CPS.
230 smr2004-Complete Line Up
To Next Page
Loading...
Need help?
General
