Section 13 PROPULSION
Subsection 01 (JET PUMP)
GENERAL
F00J0SA
5
2
1
6
3
4
1. Nozzle
2. Venturi
3. Jet pump housing
4. Wear ring
5. Impeller
6. Stator
Impeller Identification
To identify the impellers refer to the following il-
lustration and chart.
F02J0VA
1
1. Stamped part number
WATERCRAFT
MODEL
IMPELLER
P/N
MATERIAL PITCH
XP DI 271 000 920
Stainless
steel
Progressive
pitch
15° -21°
GTI, GTI LE 271 001 297
Stainless
steel
Progressive
pitch
10° -20°
GTI RFI,
GTI LE RFI
271 001 370
Stainless
steel
Progressive
pitch
11° -21°
JETPUMPINSPECTIONON
WATERCRAFT
To work on watercraft, securely install it on a
stand. Thus, if access is needed to water inlet
area, it will be easy to slide underneath watercraft.
A lift kit (P/N 295 100 206) can be used to install
watercraft on a stand.
F01J42A
1
2
TYPICAL
1. Lift kit
2. Work stand
Impeller Condition
Condition of impeller no. 1,bootno. 2 and ring
no. 3 can be quickly checked from underneath of
the watercraft. Remove grate and look through
water inlet opening.
616 smr2004-Complete Line Up
To Next Page
Loading...
Need help?
General
