DMG 3200/3100/3000 – User Manual
Page 126 (306)
IP
IP address of the SPTS/MPTS
Port
IP port number
Component
Mode
PID forwarding mode:
auto all – all components are forwarded
auto a/v – only audio and video components are forwarded
auto a/v/ttxt – audio, video and teletext components are
forwarded
Scrambler
If a scrambler module is installed, it is possible to scramble the selected
service by choosing one of the available scramblers from the pull down
menu.
ECM
If scrambling has been selected, assign the output stream to the
appropriate scrambled subscriber package
Transcoder
If a transcoder module is installed, it is possible to assign this to the new
service.
MPEG
Packets/Frame
Number of MPEG packets per UDP frame; default is 7.
Service Type
Specifies the Type-of-Service (TOS) value to prioritize between Delay,
Throughput, and Reliability. Refer to the IP protocol specification for
more details.
RTP
Enable Real Time Protocol, adds RTP header to the UDP packets.
TTL/Hop Count
Set the Time-to-Live (TTL/IPv4) or Hop Count (IPv6) value for the IP
output packets
SPTS Enabled
Enable SPTS output, streaming will start when enabled.
The properties of MPTSs and SPTSs are organized differently in the GUI to simplify the
process of configuring and maintaining these streams.
To Next Page
Loading...