DMG 3200/3100/3000 – User Manual
Page 136 (306)
Transcoder
If there is a transcoder module available in the unit, this will allow you to
allocate the service to an available transcoder port.
For each outgoing service, it is possible to manually set the signaling of EIT Present Following
or Schedule in the SDT:
Present
Following
Choose one of the following:
• Auto – If the EIT table configuration on the PSI page is set to
Play or Pass, then the SDT flag is set to 1. Otherwise, it is set
to 0.
• Present – the EIT present/following flag in the SDT is set to 1
• Not Present – the EIT present/following flag in the SDT is set
to 0
Schedule
Choose one of the following:
• Auto – If the EIT table configuration on the PSI page is set to
Play or Pass, then the SDT flag is set to 1. Otherwise, it is set
to 0.
• Present – the EIT schedule flag in the SDT is set to 1
• Not Present – the EIT schedule flag in the SDT is set to 0
If an EPG module is available and the schedule is enabled on the output, then both Present
Following and the Schedule flags are set to 1 in the SDT.
For each outgoing service, it is possible to manually set the Major and Minor channel number if
ATSC profile is active for corresponding transport stream.
If “Channel number” is set to “Auto” the numbers will be copied from the input TVCT/CVCT
tables. In “Manual” mode the values are entered in the GUI.
To Next Page
Loading...