DMG 3200/3100/3000 – User Manual
Page 264 (306)
The following Output Redundancy card setting parameters are available:
Switch delay
Specify the Switch delay
Switch back delay
Specify the Switch back delay
Figure 10.12– Output Port configuration
The following Output Port Redundancy options parameters are available:
Enable output
Redundancy
Option to Enable Redundancy on the port.
Redundancy Control
Choose one of the following options:
All – The port is signaled to be faulty if all of the outgoing
services are faulty
Majority – The port is signaled to be faulty if the majority of the
outgoing services are faulty.
One – The port is signaled to be faulty if one of the outgoing
services are faulty
To Next Page
Loading...