RM0440 Rev 4 709/2126
RM0440 Analog-to-digital converters (ADC)
724
Bits 31:27 JSQ4[4:0]: 4th conversion in the injected sequence
These bits are written by software with the channel number (0 to 18) assigned as the 4th in
the injected conversion sequence.c
Note: The software is allowed to write these bits only when JADSTART=0 (which ensures that
no injected conversion is ongoing).
Bit 26 Reserved, must be kept at reset value.
Bits 25:21 JSQ3[4:0]: 3rd conversion in the injected sequence
These bits are written by software with the channel number (0 to 18) assigned as the 3rd in
the injected conversion sequence.
Note: The software is allowed to write these bits only when JADSTART=0 (which ensures that
no injected conversion is ongoing).
Bit 20 Reserved, must be kept at reset value.
Bits 19:15 JSQ2[4:0]: 2nd conversion in the injected sequence
These bits are written by software with the channel number (0 to 18) assigned as the 2nd in
the injected conversion sequence.
Note: The software is allowed to write these bits only when JADSTART=0 (which ensures that
no injected conversion is ongoing).
Bit 14 Reserved, must be kept at reset value.
Bits 13:9 JSQ1[4:0]: 1st conversion in the injected sequence
These bits are written by software with the channel number (0 to 18) assigned as the 1st in
the injected conversion sequence.
Note: The software is allowed to write these bits only when JADSTART=0 (which ensures that
no injected conversion is ongoing).
To Next Page
Loading...
Need help?
General
