Symmetricom TimeProvider 2700 User Manual

136 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
 To provision the delay limit, the minimum interval (maximum rate) between PTP
delay response messages, for the Master with the Telecom-2008 (unicast) active
profile:
set ptp master config eth2 telecom-2008 delay-limit
<delay-limit-value>
– The interval is 2
z
seconds, where z= <delay-limit-value>.
PTP MASTER - ITU-G.8265-1 Profile Attributes:
 To provision the active profile for PTP master:
set ptp master active-profile eth2 itu-g8265-1
 To provision the state of the Two-Step Clock mode, for the Master with the
ITU-G.8265-1 (unicast) active profile:
set ptp master config eth2 itu-g8265-1 two-step {enable |
disable}
– If the Two-Step Clock state is Disable, a One-Step Clock is used.
 To provision the timescale to Automatic, Arbitrary or PTP for the Master with the
ITU-G.8265-1 (unicast) active profile:
set ptp master config eth2 itu-g8265-1 timescale {auto| arb
| ptp}
– If the timescale is set to “auto”, the TP 2300/2700 will make the decision
based on the input. The TP 2300/2700 will set the timescale to “ptp” if the
unit is locked to gnss or ptp. The TP 2300/2700 will set the timescale to
“arb” if the unit is locked to any other reference besides gnss or ptp (i.e.,
E1, T1 or SyncE).
 To provision the state for the Master with the ITU-G.8265-1 (unicast) active
profile:
set ptp master config eth2 itu-g8265-1 ptp-state {enable |
disable}
 To provision the PTP priority1 value for the Master with the ITU-G.8265-1
(unicast) active profile:
set ptp master config eth2 itu-g8265-1 priority-1
<priority-1-value>
 To provision the PTP priority-2 value for the Master with the ITU-G.8265-1
(unicast) active profile:
set ptp master config eth2 itu-g8265-1 priority-2
<priority-2-value>

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English