EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #177 background imageLoading...
Page #177 background image
098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 177
Chapter 3
TimeProvider 2300/2700 CLI Command Set
To modify the IP address, netmask, or gateway for an existing fixed (default)
VLAN configuration with IPv4 address for the PTP client port, ETH1:
set vlan config eth1 modify index 1 vlan-id <vlan-id> ipv4
address <ipv4-address> netmask <ipv4-mask> gateway
<ipv4-gateway>
To delete a fixed VLAN configuration for the specified index for the PTP client
port, ETH1:
set vlan config eth1 delete index 1
To provision the state of the fixed VLAN for the specified index for the PTP client
port, ETH1:
set vlan config eth1 state index 1 {enable | disable}
To provision PTP Server Port ETH2:
To add a fixed VLAN (default) with IPv4 address for the specified port:
set vlan config eth2 add index <1-16> vlan-id <vlan-id>
priority <priority> ipv4 address <ipv4-address> netmask
<ipv4-mask> gateway <ipv4-gateway>
To add a non-fixed VLAN with IPv4 address:
set vlan config eth2 add non-fixed vlan-id <vlan-id>
priority <priority> ipv4 address <ipv4-address> netmask
<ipv4-mask> next-hop <ipv4-addr> dest-network
<ipv4-network-prefix/prefix-length>
To modify the IP address, netmask, or gateway for an existing fixed (default)
VLAN configuration with IPv4 address on the specified port:
set vlan config eth2 modify index <1-16> vlan-id <vlan-id>
ipv4 address <ipv4-address> netmask <ipv4-mask> gateway
<ipv4-gateway>
To modify the IP address, netmask, or gateway for an existing non-fixed VLAN
configuration on the specified port:
set vlan config eth2 modify non-fixed vlan-id <vlan-id> ipv4
address <ipv4-address> netmask <ipv4-mask> next-hop
<ipv4-addr> dest-network <ipv4-network-prefix/prefix-length>
To delete a fixed VLAN configuration for the specified index on the specified port:
set vlan config eth2 delete index <1-16>
To delete a non-fixed VLAN configuration for the specified VLAN ID on the
specified port:
Note: If a gateway router is not required, then set the gateway value
to the special value of 0.0.0.0

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish