Symmetricom TimeProvider 2700 User Manual

098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 179
Chapter 3
TimeProvider 2300/2700 CLI Command Set
Example 2a PTP Server Port:
To add a non-fixed VLAN on PTP server port ETH2 with VLAN ID = 99, Priority=5,
where the IP address= 192.168.3.20, Netmask=255.255.255.0, Next
Hop=192.168.3.1 and Destination Network/Net-Prefix=192.168.3.0/24
TP2700> set vlan config eth2 add non-fixed vlan-id 99
priority 5 ipv4 address 192.168.3.20 netmask 255.255.255.0
next-hop 192.168.3.1 dest-network 192.168.3.0/24
Example 3
PTP Server Port:
To modify Index 3 on an existing fixed VLAN on PTP server port ETH2 with the new
IP address of 192.168.1.7, Netmask=255.255.255.0, and Gateway=192.168.1.1:
TP2700> set vlan config eth2 modify index 3 ipv4 address
192.168.1.7 netmask 255.255.255.0 gateway 192.168.1.1
Example 3a
PTP Server Port:
To modify the existing non-fixed VLAN with VLAN ID of 99 on PTP server port ETH2
with the new IP address of 192.168.3.35, Netmask=255.255.255.0, Next
Hop=192.168.3.1 and Destination Network/Net-Prefix=192.168.3.0/24:
TP2700> set vlan config eth2 modify non-fixed vlan-id 99
ipv4 address 192.168.3.35 netmask 255.255.255.0 next-hop
192.168.3.1 dest-network 192.168.3.0/24
Example 4
PTP Server Port:
To delete the fixed VLAN configuration for Index 4 on ETH2 port:
TP2700> set vlan config eth2 delete index 4
Example 4a
PTP Server Port:
To delete the non-fixed VLAN configuration for VLAN ID=75 on ETH1 port:
TP2700> set vlan config eth2 delete non-fixed vlan-id 75
Example 5
PTP Server Port:
To Enable the fixed VLAN configuration for Index 3 on ETH1:
TP2700> set vlan config eth2 state index 3 enable
Example 5a
PTP Server Port:
To Enable the non-fixed VLAN configuration for VLAN ID=75 on PTP server port
ETH2:

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English