Symmetricom TimeProvider 2700 User Manual

098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 281
Appendix A System Messages
System Notification Messages
PTP state changed
to master on ETH2
077 Event Yes PTP state changed to
master on ETH2
n/a
No action required
n/a
PTP state changed
to passive on ETH2
078 Event Yes PTP state changed to
passive on ETH2
n/a
Another master has been
selected because of
better quality.
n/a
GNSS receiver
communications
failed
091 Minor No GNSS receiver
c o m m u n i c a t i o n s f a i l e d
GNSS receiver
communications
failure cleared
 Reboot
 If problem persists
call SGS for support.
No action required
GNSS receiver not
tracking satellite
092 Minor No GNSS receiver not
tracking satellite
GNSS receiver not
tracking satellite cleared
 Check Antenna
installation
 Check if Antenna
cable is connected
properly.
 Installation should
conform to the
guidelines as
described in
Appendix C.
No action required
Table A-1. System Notification Messages (Continued)
Description
Event
ID
Msg
Level
Trans-
itory
MsgText Corrective Action

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English