Symmetricom TimeProvider 2700 User Manual

282 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Appendix A System Messages
System Notification Messages
GNSS signal low 093 Minor No GNSS signal low
GNSS signal normal
 Check Antenna
installation
 Check if Antenna
cable is connected
properly.
 Installation should
conform to the
guidelines as
described in
Appendix C.
No action required
GNSS antenna
voltage out of range
(#)
094 Major No GNSS antenna voltage
out of range (#)
GNSS antenna voltage
out of range cleared
Check for short circuit in
the antenna cable.
No action required
GNSS antenna
current out of range
(#)
095 Major No GNSS antenna current
out of range (#)
GNSS antenna current
out of range cleared
Not supported at this
time.
No action required
GNSS antenna
short-circuit
096 Minor No GNSS antenna
short-circuit
GNSS antenna
short-circuit cleared
Check for short circuit in
the antenna cable.
No action required
GNSS antenna
open-circuit
097 Minor No GNSS antenna
open-circuit
GNSS antenna
open-circuit cleared
Check for Antenna not
connected or AC coupled
splitter. If using a splitter
you must at least draw
10mA of current from the
TP2700. This can be
achieved by adding a 50
ohm termination.
No action required
Table A-1. System Notification Messages (Continued)
Description
Event
ID
Msg
Level
Trans-
itory
MsgText Corrective Action

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English