TOMATECH AUTOMATION
208
Ⅱ Operation
should be cut off immediately to avoid the accidents. But it should be noted that there may
be a large
error between the CNC coordinates displayed and the actual position. So the toolsetting
operation
should be performed again.
Chapter 3 Manual Operation
209
Ⅱ Operation
CHAPTER 3 MANUAL OPERATION
Press key, it enters Manual mode. In the mode, the system can perform the manual feed,
spindle control, override adjustment, tool change etc..
3.1 Coordinate Axis Move
In Manual mode, 2 coordinate axes can perform manual feeding and rapid traverse.
3.1.1 Manual feed
Press or in and X feeds negatively or positively, and its
feeding stops if the key is released; press or and Z axis feeds negatively or positively,
and its feeding stops if the key is released; press or , and Y feeds negatively or
positively, and its feeding stops if the key is released; press or and the 4th axis
feeds negatively or positively, and its feeding stops if the key is released; press or and
the 5th axis feeds negatively or positively, and its feeding stops if the key is released.
In Manual mode, press key to make the indicator enter the manual rapid traverse mode.
3.1.2 Manual rapid traverse
Note!
The key functions of thisTAC-1002T machine panel are defined by PLC
program (ladders), please refer to the manual from the machine builder for
their
function significance.
Please note that the following functions for the machine panel keys are
described based on theTAC-1002T standard PLC programs!
210
Ⅱ Operation
Press in and the key indicator is ON; press or and X
feeds negatively or positively, and its feeding stops if the key is released; press or and Z
axis feeds negatively or positively, and its feeding stops if the key is released; press or ,
and Y feeds negatively or positively, and its feeding stops if the key is released; press or
and the 4th axis feeds negatively or positively, and its feeding stops if the key is released;
To Next Page
Loading...
Need help?
General