TOMATECH TAC-100XT User Manual

TOMATECH AUTOMATION
PLC data: DT021: spindle stops, chuck operation enabling delays(ms).
Note: The chuck function is only forTAC-1002T-V CNC system.
3.2.6 Tailstock control
: In any mode, press it to switch the tailstock forward/backward.
Function description:
When the tailstock control is invalid, the tailstock control M command alarms;
When the tailstock and the spindle control is interlocked, before the spindle is started, the
system
check whether the tailstock forward is valid. After the spindle is started, the tailstock
backward cannot
be executed.
Parameter setting:
PLC parameter：K13.0 1/0：tailstock control valid/invalid
PLC parameter：K13.1 1/0：the spindle rotation and the tailstock forward/backward are/not
interlocked
Note: The tailstock function is only for TOMATECH 980TDc-V CNC system.
3.2.7 Hydraulic control
: press it to switch the hydraulic motor ON/OFF in any mode.
Function description:
When the hydraulic control function is valid, is pressed to control HPST output to start the
hydraulic motor.
When the system is in non-run, the spindle stops and the speed is zero, is pressed to
close HPST output.
Parameter setting:
PLC parameter: K14.7 1/0: hydraulic control function valid/invalid
Note: The hydraulic function key is only forTAC-1002T-V CNC system.
3.2.8 Manual tool change
: In Manual mode, pressing the key can manually change tools in sequence (if current tool
is No.1, it is changed for No.2 tool by pressing it; if current tool is No.4, it is changed for
No.1 tool by
pressing it.
214
Ⅱ Operation
3.2.9 Spindle override
In Manual mode, if the spindle speed is controlled by analog voltage output, the spindle
speed
may be overrided.
Pressing , can change the spindle speed in real-time to adjust 8 steps of 50％～120
％ of the spindle override.

TOMATECH TAC-100XT Specifications

General

Brand	TOMATECH
Model	TAC-100XT
Category	Control Systems
Language	English