TOMATECH AUTOMATION
Volume Ⅲ Connection
0: Axial output wave is square;
0 0 6 *** *** *** ZM5 ZM4 ZMY ZMZ ZMX
Bit4 1: 5th zero return mode C
0: 5th zero return mode B
Bit3 1: 4th zero return mode C
0: 4th zero return mode B
Bit2 1: Y zero return type C
0: Y zero return type B
Bit1 1: Z zero return type C
0: Z zero return type B
Bit0 1: X zero return type C
0: X zero return type B
0 0 7 DISP *** SMZ ZC5 ZC4 ZCY ZCZ ZCX
Bit7 1: Enter ABSOLUTE POS page after power on
0: Enter RELATIVE POS page after power on
Bit5 1: Execute the next block after all motion block exactly are executed to the in-position
0: Smooth transition between two blocks
Bit4 1: In machine zero return, 5th deceleration signal (DEC5) and one-revolution signal
(PC5) are
parallel(use one proximity switch as the deceleration signal and zero signal)
0: In machine zero return, 5th deceleration (DEC5) and one-revolution signal (PC5) is
separately connected (need the separate deceleration signal and zero signal)
Bit3 1: In machine zero return, 4th deceleration signal (DEC4) and one-revolution signal
(PC4) are
parallel(use one proximity switch as the deceleration signal and zero signal)
0: In machine zero return, 4th deceleration (DEC4) and one-revolution signal (PC4) is
separately connected (need the separate deceleration signal and zero signal)
Bit2 1: DECY and PCY signals are in parallel (a proximity switch taken as both DECY and
zero
signals) during machine zero return
0: DECY and PCY signals are separate (separate DECY and zero signals needed) during
machine zero return
Bit1 1: DECZ and PCZ signals are in parallel (a proximity switch taken as both DECZ and
zero
signals) during machine zero return
0: DECZ and PCZ signals are separate (separate DECZ and zero signals needed) during
machine zero return
Bit0 1: DECX and PCX signals are in parallel (a proximity switch taken as both DECX and
zero
signals) during machine zero return
0: DECX and PCX signals are separate (separate DECX and zero signals needed) during
machine zero return
0 0 8 *** *** *** DIR5 DIR4 DIRY DIRZ DIRX
To Next Page
Loading...
Need help?
General