TOMATECH AUTOMATION
Russian 1 1 0
1 8 5 SK0 SKF AEO *** *** *** PRPD PLA
Bit7 1: Skip input active as G31 signal is 0
Chapter 3 Parameters
377
Volume Ⅲ Connection
0: Skip input active as G31 signal is 1
Bit6 1: Feedrate override per minute or dry run active for G31
0: Feedrate override per minute or dry run inactive for G31
Bit5 1: Input active if G36, G37 (XAE, ZAE) signal is 0
0: Input active if G36, G37 (XAE, ZAE) signal is 1
Bit1 1: Axis rapid traverse rate of PLC by input value
0: Axis rapid traverse rate of PLC by parameter value (X axis: No.022；Z axis:No.023；Y
axis:No.134)
Bit0 1: PLC axis control active, active after repowering
0: PLC axis control inactive, active after repowering
1 8 6 RTORI SRS *** *** *** RTCRG *** ***
Bit7 1: In executing M29, the spindle executes the machine zero return
0: In executing M29, the spindle does not execute the machine zero return
Bit6 1: The spindle selection signal is RGTSPn in the multiple spindle rigid tapping
0: The spindle selection signal is SWSn in the multiple spindle rigid tapping
Bit2 1: In rigid tapping cancel, do not wait for G61.0 to be 0 in executing the next block
0: In rigid tapping cancel, wait for G61.0 to be 0 in executing the next block
1 8 7 IS1 IS0 RCS *** *** *** ROS ROT
[Data type]：Bit axis
BIT7, BIT6：set increment system of each axis.00：accordance with increment system of
the system.
01：IS-A，10：IS-B；11：IS-C。
Bit5 1：Cs axis function of the additional axis is valid (power-on again);
0：Cs axis function of the additional axis is invalid (power-on again).
Bit1, Bit0 : 00: set the additional axis to the linear axis; 01: set the additional axis to the
rotary axis
（A type）;11: set the additional axis to the rotary axis (B type); 10: set the additional
axis to be invalid.
Note: The parameter is invalid to setting of X, Z axis.
1 8 8 *** RRT *** *** *** RRL RAB ROA
[Data type]：bit axis
Bit6 1：Zero return D mode is used when the additional axis is a rotary axis;
0：Zero return A, B, C mode is used when the additional axis is a rotary axis (power-on
again).
Bit2 1：The relative coordinate cycle function is valid when the additional axis is rotary;
0：The relative coordinate cycle function is invalid when the additional axis is
rotary(power-on
again).
To Next Page
Loading...