TOMATECH AUTOMATION
Bit2 1: Y movement key is positive， is negative
0: Y movement key is positive， is negative
Bit1 1: Z movement key is positive， is negative
0: Z movement key is positive， is negative
Bit0 1: X movement key is positive， is negative
0: X movement key is positive， is negative
1 8 0 NAT *** *** *** *** *** *** SPOS
Bit7 1: Function ATAN, ASIN range is 90.0～270.0;
0: Function ATAN, ASIN range is -90.0～90.0
Bit0 1: DIS TO GO displayed in POS&PRG page
0: RELATIVE POS displayed in POS&PRG page
376
Volume Ⅲ Connection
1 8 1 RLC MRC ZCL *** MCL *** *** LCNMD
Bit7 1: G52 local coordinate system is cancelled after reset;
0: G52 local coordinate system is not cancelled after reset;
Bit6 1: G52 local coordinate system is cancelled after the execution of M30, M02;
0: G52 local coordinate system is not cancelled after the execution of M30, M02;
Bit5 1: G52 local coordinate system is cancelled after reference point return;
0: G52 local coordinate system is not cancelled after reference point return;
Bit3 1: Blocks edited in MDI mode are deleted after reset;
0: Block edited in MDI mode are not deleted after reset;
Bit0 1: In linear chamfering, L means the length between chamfering point and cross
point;
0: In linear chamfering, L means the length of chamfering;
1 8 3 *** *** *** MZR5 MZR4 MZRY MZRZ MARX
Bit4 1: for 5th, press key to execute the machine zero return
0:for 5th, press key to execute the machine zero return
Bit3 1: for 4th, press to execute the machine zero return
0: for 4th, press to execute the machine zero return
Bit2 1: for Y, press to execute the machine zero return
0: for Y, press to execute the machine zero return
Bit1 1:for Z, press to execute the machine zero return
0: for Z, press to execute the machine zero return
Bit0 1: for X, press to execute the machine zero return
0: for X, press to execute the machine zero return
1 8 4 *** *** *** *** *** L2 L1 L0
Bit0, Bit1, Bit2: Language selection:
Language Bit2 Bit1 Bit0
Chinese 0 0 0
English 0 0 1
Portuguese 0 1 0
Spanish 0 1 1
To Next Page
Loading...