TOMATECH AUTOMATION
Bit3 1: Movement direction discrimination is valid during offset measurement 4 point input;
0: Movement direction discrimination is invalid during offset measurement 4 point input;
Bit2 1: Tool offset number is set through G signal;
0: Tool offset number is set through the current cursor;
Bit1 1 Tool offset measurement detection signal is valid at low level;
0: Tool offset measurement detection signal is valid at high level;
Bit0 1:Tool offset automatic measurement detection signal 1 point input;
0: Tool offset automatic measurement detection signal 4-point input;
1 7 2 *** MST MSP MOT ESP *** LZR ***
Bit6 1: External cycle start signal (ST) inactive, it is not the cycle start switch and can be
defined
by macro code (#1014)
0: External cycle start signal (ST) active
Bit5 1: External SP signal inactive, and it is not the stop switch and can be defined by
macro
code.( #1015)
Chapter 3 Parameters
375
Volume Ⅲ Connection
0: External SP signal active with external dwell switch needed, otherwise CNC shows
“Stop”.mailto:M@SP=1
Bit4 1: Not detect software stroke limit
0: Detect software stroke limit
Bit3 1: Emergency stop inactive
0: Emergency stop active
Bit1 1: Software limit is inactive after power-on and before machine zero return;
0: Software limit is active after power-on and before machine zero return;
1 7 4 *** *** *** *** KEY1 *** *** ***
Bit3 1: Program switch ON at power on
0: Program switch OFF at power on
1 7 5 SPFD SAR THDA VAL5 VAL4 VALY VALZ VALX
Bit7 1: In cutting feed, do not permit the spindle stopping rotation; the spindle stops, the
feed also
stops when the system appears No.404 alarm cutting
0: In cutting feed, permit the spindle stops rotation; the spindle stops rotation, but the feed
does not stop
Bit6 1: Detect spindle SAR signal prior to cutting
0: Not detect spindle SAR signal prior to cutting
Bit5 1: Thread machining is the exponential acceleration/deceleration
0: Thread machining is the linear acceleration/deceleration
Bit4 1: 5th movement key is positive, is negative
0: 5th movement key is positive, is negative
Bit3 1: 4th movement key is positive, is negative
0: 4th movement key is positive， is negative
To Next Page
Loading...