TOMATECH AUTOMATION
CMR 4* *δ *
=
Δ: Least command increment;
ZM: Teeth number of pulley on leading screw side;
C: Motor encoder line number;
ZD Teeth number of pulley on motor side;
L: Screw lead
0 1 9 THDCH
［Data meaning］ Run-out length in threading
［Data range］ 0～225
Thread run-out width= THDCH×0.1×screw lead
0 2 1 PSANGNT
［Data type］ Word spindle
Chapter 3 Parameters
379
Volume Ⅲ Connection
［Data meaning］ Voltage offset value when spindle max. speed analog voltage output is
10V
［Data unit］ mV
［Data range］ -2000～2000(Unit: mV)
0 2 2 RPDFn
［Data type］ Word axis
［Data meaning］ Maximum rapid traverse rate of all axes
［Data unit］
Setting unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］ 10～99999999
0 2 3 LINTn
［Data type］ Word axis
［Data meaning］ Acceleration/deceleration time constant of each axis during rapid
traverse
［Data unit］ ms
［Data range］ 0~4000
0 2 6 THRDT
［Data meaning］ ACC&DEC time constant of short axis in thread run-out
［Data unit］ ms
［Data range］ 0～4000
0 2 7 FEDMX
Data meaning］ Upper limits of axis cutting feed
［Data unit］
Setting unit Data unit
To Next Page