TOMATECH TAC-100XT - Page 318

TOMATECH AUTOMATION
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］
IS-B IS-C
Metric machine 10～15000 10～15000
Inch machine 5～5800 10～5800
0 2 8 THDFL
［Data meaning］ X, Z initial speed in threading (mm/min)
［Data unit］
Setting unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］
IS-B IS-C
380
Volume Ⅲ Connection
Metric
machine 6～8000 6～8000
Inch machine 3～3000 3～3000
0 2 9 FEEDT
［Data meaning］ Exponential ACC&DEC time constant of cutting and manual feed
［Data unit］ ms
［Data range］ 0～4000
0 3 0 FEDFL
［Data meaning］ Exponential acceleration start speed and deceleration end speed in
cutting
feed
［Data unit］
Setting unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］
IS-B IS-C
Metric machine 0～8000 0～8000
Inch machine 0～3000 0～3000
0 3 1 JOGSPEED
［Data meaning］ the set speed when the manual feedrate override is 100%
［Data unit］
Setting unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］ 10～30000
0 3 2 RPDFLn