TOMATECH AUTOMATION
program
code in auto running
［Data unit］
Setting unit IS-B IS-C
Metric input 0.001 mm 0.0001 mm
Inch input 0.0001 inch 0.00001 inch
［Data range］ -9999999～9999999
0 5 5 PATIM
［Data meaning］ Cycle times of G73, which may also be changed by program code in
auto
running
384
Volume Ⅲ Connection
［Data unit］ times
［Data range］ 1～9999
0 5 6 GROVE
［Data meaning］ Retraction value of Z axis in G74; retraction value of X axis in G75; a
specified
value in program during automatic running can also change the setting of this
parameter;
［Data unit］
Setting unit IS-B IS-C
Metric input 0.001 mm 0.0001 mm
Inch input 0.0001 inch 0.00001 inch
［Data range］ 0～99999
0 5 7 THRPT
［Data meaning］ Repetitions of G76 finish machining, which may also be changed by
program
code in auto running
［Data unit］ times
［Data range］ 1～99
0 5 8 THANG
［Data meaning］ Tool nose angle of G76 cycle, which may also be changed by program
code in
auto running
［Data unit］ deg
［Data range］ 0～99
0 5 9 THCLM
［Data meaning］ Min. cut depth of G76 cycle, which may also be changed by program
code in
auto running
［Data unit］
Setting unit IS-B IS-C
To Next Page