TOMATECH AUTOMATION
K 1 3 SPTW SLTW
SLTW =1: tailstock control function is valid;
=0: tailstock control function is invalid.
SPTW =1: the spindle rotation and the tailstock forward/backward does not interlock, the
tailstock can execute the tailstock forward/backward no matter what the spindle is in
any states;
=0: the spindle rotation and the tailstock forward/backward interlock. When the spindle
rotates, the tailstock does not go backward; when it does not go forward, the spindle
must not be started.
K 1 4 SPB4 PB4 SPB3 PB3
PB3 =0: pressure low check function is invalid;
=1: pressure low check function is valid.
SPB3 =0: when PRES is connected with +24V，the system alarms for pressure low；
=1: when PRES is not connected with +24V，the system alarms for pressure low.
PB4 =0: safety door check function is invalid;
=1: safety door check function is valid.
SPB4 =0: when SAGT is not connected with +24V, the safety door is closed;
=1: when SAGT is connected with +24V, the safety door is closed.
K 1 5 RCS RSCS SHT AGIM AGIN AGER
AGER =1: Spindle automatic gearing active
=0: Spindle automatic gearing inactive
AGIN =1: Detect M41I, M42I signal when automatically gearing to gear 1, 2
=0: Not detect M41I, M42I signal when automatically gearing to gear 1, 2
AGIM =1: M41I, M42I signals active when connecting to 0V
=0: M41I, M42I signals active when connecting to +24V
SHT =1: the spindle gear power-down memorizes;
=0: the spindle gear power-down does not memorize.
Chapter 5 Diagnosis Message
443
Ⅲ Connection
RSCS =1: close the spindle contour control in emergent stop, reset;
=0: does not close the spindle contour control in emergent stop, reset
RCS =1: Cs function is valid；
=0: Cs function is invalid.
K 1 6 SINC M32A ROVI SOVI
SINC 1: in Step(MPG) mode, ×1000 is invalid, ×1, ×10, ×100 are valid；
0: in Step(MPG) mode, ×1, ×10, ×100, ×1000 are valid.
SOVI =1: external feedrate override switch is valid;
=0: external feedrate override switch is invalid.
ROVI =1: external feedrate override is reverse;
=0: external feedrate override is not reverse.
M32A =1: output the lubricating in starting the system when the automatic lubricating is
valid;
=0: do not output the lubricating in starting the system when the automatic lubricating is
To Next Page
Loading...