TOMATECH AUTOMATION
signal
A0003.3 1027 Tool pot is not released or lock signal is not cancelled
A0003.4 1028 Has not found the target tool number
A0003.5 1029 Has not received tool pot stop and locking start signal
A0003.7 1031 Total tools is more than 4, and the external override
cannot be connected (address multiplexing)
A0004.0 1032 Illegal M code
A0004.1 1033 The current spindle is not analog, and Jog function
cannot be executed
A0004.2 1034 M03,M04 specification are mistaken
A0004.3 1035 M63,M64 specification are mistaken
A0004.4 1036 Spindle gear shift time is too long
A0004.5 1037 Spindle speed/position control switch time is too long
470
Appendix
A0004.6 1038 The 2nd spindle speed/position control switch time is too
long
A0004.7 1039 Spindle position control does not permit orientation
A0005.0 1040 Spindle orientation time is too long
A0005.1 1041 Alarm for the abnormal spindle servo or frequency
converter for abnormality
A0005.2 1042 Alarm for the abnormal 2nd spindle servo or frequency
converter
A0005.3 1043 Forbid clamping the spindle when the spindle rotating or
feeding
A0005.4 1044 Spindle is clamped not to rotate or feed
A0007.0 2000 Hydraulic motor is not started
A0007.1 2001 Safety door has been opened
A0007.3 2003 Alarm for the tool pot unclocked
A0007.5 2005 Regulation is invalid when feedrate override is fixed to
100%
A0007.6 2006 Override on the panel is disabled when external override
is enabled
A0007.7 2007 Program does not run when external pause switch is
OFF
A0008.0 2008 Axis does not move when manual override is 0
ed to their items correspondingly.__
To Previous Page
Loading...