TOMATECH AUTOMATION
469
Appendix
No. Content Remark
904 Loaded pitch compensation file is mistaken
905 Loaded workpiece coordinate file is mistaken
906 Starting PLC program is mistaken. Confirm whether the ladder exists and
is correct
909 Limited-time stop time is over and the system cannot run normally. Please
contact with salesmen
999 There is an unknown alarm. Please contact with developers
2. PLC alarm（standard PLC ladder definition）
Address Alarm No. Content
A0000.0 1000 Tool change time is too long
A0000.1 1001 Alarm for the tool is not in-position when tool change
ends
A0000.2 1002 Alarm for the tool change is not completed
A0000.3 1003 Alarm for the system has not received the lock signal
A0000.4 1004 The system repetitively checks the lock signal and the
lock signal is invalid when tool change is done
A0000.5 1005 Tool change makes mistakes before the system is turned
off
A0000.6 1006 Pre-indexing proximity switch does not reach
A0000.7 1007 Alarm for tool post overheat
A0001.0 1008 Tailstock function is invalid, and M10 and M11 cannot be
executed
A0001.1 1009 The thread run-out cannot be executed when the spindle
rotating
A0001.3 1011 Have not checked the tailstock forward and cannot start
the spindle
A0001.4 1012 Tool change mode A and B can have up to 8 tools
A0001.5 1013 Tool use life ends
A0001.6 1014 Confirm tool number of tool post (8, 10, 12)
A0001.7 1015 Confirm tool number of tool post (6, 8, 10, 12)
A0002.0 1016 Alarm for protection door not closed
A0002.1 1017 Alarm for pressure low
A0002.3 1019 Can’t release chuck when spindle rotating
A0002.4 1020 Alarm for disabled clamping in-position signal when
spindle rotating
A0002.5 1021 Can’t start spindle when disabled clamping in-position
signal
A0002.6 1022 Can’t start spindle when chuck is released
A0003.0 1024 Can’t execute M12 or M13 with disabled chuck function
A0003.1 1025 Have not checked chuck clamping/releasing in-position
To Next Page
Loading...