TOMATECH AUTOMATION
Press reset to
clear the alarm,
positively move
X
418 Exceeding Y negative software travel limit
Press reset to
clear the alarm,
negatively move
Z
419 Exceeding 4th negative software travel limit
Press reset to
clear the alarm,
positively move
X
420 Exceeding 5th negative software travel limit
421 X drive unit is not ready
422 Z drive unit is not ready
423 Y positive overtravel
424 4th positive overtravel
425 5th positive overtravel
426 X negative overtravel
427 Z negative overtravel
428 Y negative overtravel
429 4th negative overtravel
430 5th negative overtravel
431 X drive unit have not been ready
432 Z drive unit have not been ready
433 Y drive unit have not been ready
434 4th drive unit have not been ready
435 5th drive unit have not been ready
437 PLC axis is working and cannot be switched
438 CNC axis is working and cannot be switched
439 PLC axis is working and cannot be operated
440 CNC emergent stop is failure(restart the CNC)
450
Data is error! Start the system again to return the machine zero, execute
the toolsetting again to check all parameters
451 Definition of output axis number is mistaken. Please modify No. 226
900 Loaded system allocation file is mistaken. Confirm whether cnc.cfg. exists
901 Loaded system allocation file is mistaken. Confirm whether param.cfg.
exists
902 Loaded parameter value file is mistaken
903 Loaded tool offset file is mistaken
Appendix
To Next Page
Loading...