TOMATECH AUTOMATION
354 The system parameter is modified, and is turned on again
356 Modifying the ladder is successful, please turn on the CNC again
361
The least incremental system setting of additional axis(Y,4th,5th) cannot be
less than the least incremental system (IS-B,IS-C)of the current system,
please set it again
401 The program reference point is not specified
Press reset to
clear alarm, set
program zero in
G50
402
Max. spindle speed at some gear is not specified and check
No.037~No.040
403 Run speed is too rapid
404 Feedrate is cancelled owing to spindle stopping
405 Spindle speed is too low when machining thread
406 Feedrate exceeds the upper value (No.027) when thread machining
Press reset
to clear the
alarm, check the
spindle and
modify NO.106
407 Fluctuation of spindle speed is excessive when machining thread
408 Pitch is less than 0 when the variable pitch is machined
409
The reference point is not created, and 2nd, 3rd, 4th reference point return
cannot be executed
410 Zero return mode A, zero return failure
411 Exceeding X axis positive software travel limit
412 Exceeding Z axis positive software travel limit
413 Exceeding Y axis positive software travel limit
468
Appendix
No. Content Remark
414 Exceeding the 4th axis software travel limit
415 Exceeding the 5th axis software travel limit
416 Exceeding X negative software travel limit
Press reset to
clear the alarm,
negatively move
X
417 Exceeding Z negative software travel limit
To Next Page
Loading...