TOMATECH AUTOMATION
and the cylinder interpolation
295
C tool compensation is not cancelled in the polar coordinates and the
cylinder interpolation
301 Parameter switch has been on
302 CNC initialization is failure
303 Cannot open part programs
304 Fail to save part programs
305 Total lines of part program exceed its range (69993)
306 Illegal dictates have been input
307 Memory capacity is not enough
308 Program numbers exceed the range
309 Editing macro program is forbidden under its current operation authority
310 Cannot open PLC programs (ladder)
311 Edit software version of PLC programs (ladder) is inconsistent
312 First-grade PLC program is too long
Appendix
467
Appendix
No. Content Remark
313 The edit keyboard or operator panel is failure
314 The memorizer is failure, check it or power on again
315 Electronic gear ratio setting is mistaken
316 Set the rotary axis function be to valid before using CS axis or rigid tapping
317
CS axis position is mistaken(must not switch the spindle working mode
when CS axis is working)
318
Cannot move CS axis when the spindle is not switched to the position
control mode
320 CPU voltage is abnormal. Please check the power supply and restart
321 NVRAM data check is mistaken
322 Saving NVRAM data time is too short when the latest power-down
324 There is only basic axis XYZ. Set No. 230 again
325
Cannot set simultaneously two or more CS axis to be valid when the
multi-spindle control function is invalid or the 2nd CS function is not started
326
Y axis cannot set to CS controllable axis when the multi-spindle control
function is valid and the 2nd CS function is valid
330
The axis name of additional axis is not in the setting range or, the axis
names of two or more than two additional are the same ones. Please set
No. 225 again
To Next Page
Loading...