TOMATECH AUTOMATION
Arc radius is less than that of tool nose to cause not to execute C tool
nose radius compensation
466
Appendix
No. Content Remark
257
Mistake in programming causes there is not intersection of two arcs of
current tool radius in the course of C tool nose radius compensation
258 Specify one arc command as executing C tool nose radius compensation
259 Specify one arc command as canceling C tool nose radius compensation
260 There is excessive cutting as checking C tool nose radius compensation
261
Mistake in programming causes there is not intersection between straight
line and arc of current tool radius in the course of C tool nose radius
compensation
262
Mistake in programming causes there is not intersection between arc and
straight line of current tool radius in the course of C tool nose radius
compensation
263
There are too non movement commands in C too radius compensation,
the buffer overflows
281 The linear chamfer length is too length
282 The arc chamfer radius is too big
283 The linear chamfer length is too big or the arc data is mistaken
284 The arc chamfer radius is too big or the arc data is mistaken
285 The linear chamfer length is too big or the arc data is mistaken
286 The arc chamfer radius is too big or the arc data is mistaken
287 The linear chamfer length is too big or the intersection is not on the arc
288 The arc chamfer radius is too big or the intersection is not on the arc
289 The chamfer cannot be executed in end position
290
Cannot start the polar coordinate and the cylinder interpolation in C tool
compensation state or G99
291
The linear axis or rotary axis of the polar coordinates does not correspond
to No.189 or the linear axis attribution setting is mistaken
292
Execute the length compensation of all axes before starting the polar
coordinates
293 X cannot be negative or 0 in G16/G15
294
Have used the command which cannot be used to the polar coordinates
To Next Page
Loading...
Need help?
General