TOMATECH AUTOMATION
146 The anti logarithm of LN in macro statement is 0 or less than 0
147 The square root in macro statement cannot be negative
148 The tangent TAN result in macro statement is endless
149
The operands of anti sine or anti cosine in macro statement exceed the
range between -1 and 1
150
The macro variable number or the variable value is illegal(error) in macro
statement
151 The local variable is empty
152 The variable #0 is always empty and cannot be operated
153 The operand in macro statement is not binary
155 Format of program note is mistaken (mismatching)
232 Specify the axis movement command in M29 or G84/G88
233 Rigid tapping signal (G61.0) in rigid tapping mode is abnormal
234 Specify M29 repetitively or not input M29 before rigid tapping
235
The spindle must be oriented, M29 cannot be with G84/G88 in the same
block when rigid tapping
236
Set the axis used to the spindle control to the rotary axis before the rigid
tapping/rigid thread machining
238
Have not selected the spindle used to the rigid tapping for the multi-spindle
function device when rigid tapping
239 Cannot switch the spindle used to the tapping when rigid tapping
251
Mistake in programming causes an error of C tool nose radius
compensation
252
Mistake in programming causes an end point of arc machining is not on
the arc in the course of C tool nose radius compensation
253
Mistake in programming causes there are the same coordinates for two
neighboring points not to execute C tool nose radius compensation
254
Mistake in programming causes there are the same coordinates between
center point and starting point of arc not to execute C tool nose radius
compensation
255
Mistake in programming causes there are the same coordinates between
center point and end point of arc not to execute C tool nose radius
compensation
256
To Next Page
Loading...
Need help?
General